☀
Account Enter the Lab
Courses  /  Science  /  Making the Board
Science

Making the Board

Turn a schematic into a working board: KiCad layout, laser-made copper, solder mask, drilling, soldering, and a safe first power-up.
8 levels 45 lessons All ages Taught by Tesla 0 of 45 complete
THE SYLLABUS
I
Schematic to Layout in KiCad

0 / 6
▶
The KiCad Workflow
A board goes Schematic → Annotate → ERC → Assign footprints → Update PCB → Layout → DRC → Plot. The circuit lives in the schematic; the PCB only implements it. ERC checks the schematic before the handoff, DRC checks the copper before you plot.
Start
🔒
Drawing the Schematic
The schematic is the source of truth: place the symbols (one LM324 gives units U1A–U1D plus a power unit), wire pin to pin, and use net labels or power symbols: two labels with the same name are one net. Only a wire end on a pin or a junction dot connects.
Premium
🔒
Annotation and ERC
Annotate gives every part a unique reference (R? → R1, R2…). ERC then checks the schematic's electrical sense: a rail fed from a connector needs a PWR_FLAG, pins left open on purpose need a no-connect flag, and a duplicate reference needs re-annotating. Many ERC messages are real missing wires: fix them all before the board.
Premium
🔒
Footprints, Netlist and Ratsnest
Update PCB from Schematic carries the footprints and the netlist across: the parts arrive in a pile, tied by thin ratsnest lines, one for each connection still to be made in copper. Ratsnest lines are reminders, not traces. Change the schematic, and Update PCB again to re-sync.
Premium
🔒
Board Outline and Placement
Draw the outline on Edge.Cuts, then place before you route: decoupling caps within a few mm of the IC power pins, connectors at the edge, and input parts in the order the signal flows, so their ratsnest lines are short and don't cross. Good placement is most of good routing.
Premium
🔒
Level Review
Level 1 review: the KiCad workflow in order, ERC fixes, reading the ratsnest, placement choices, two schematic faults, and two items from Seeing Circuits.
Premium
II
Footprints and Design Rules

🔒 5 lessons
III
Single-Sided Routing and Ground Pours

🔒 6 lessons
IV
Exporting the Copper Layer as SVG

🔒 5 lessons
V
Laser PCB Fabrication

🔒 6 lessons
VI
Solder Mask and Curing

🔒 5 lessons
VII
Drilling and Soldering

🔒 6 lessons
VIII
Testing and Debug

🔒 6 lessons